ISSN 0892-6298
Vol. 25, Issue 3-4, 2008December 31, 2008 CDT
Evaluation of User’s Ability to Seal Respirator Cartridge Inlet Openings of Different Sizes and Shapes
Evaluation of User’s Ability to Seal Respirator Cartridge Inlet Openings of Different Sizes and Shapes
Articles in Vol. 25, Issue 3-4, 2008
Vol. 25, Issue 3-4, 2008
- Inclusion of African-American Male Respirator Wearers in the NIOSH Bivariate Fit Test Panel and the Los Alamos National Laboratory Full-Facepiece and Half-Mask PanelsRiedar K. OestenstadElizabeth H. MaplesT. Mark Beasley
- Experimental and Theoretical Investigation of the Performance of N95 Respirator Filters Against Ultrafine Aerosol Particles Tested at Constant and Cyclic FlowsHiroki HarutaTakeshi HondaRobert M. EningerTiina ReponenRoy McKaySergey A. Grinshpun*
- Evaluation of User's Ability to Seal Respirator Cartridge Inlet Openings of Different Sizes and ShapesOtto W. Rusch IIITiina ReponenChristopher J. RonkRoy T. McKay
- Performance of Breath-Synchronized Powered Air-Purifying Respirator Under Simulated Usage ConditionsHisashi Yuasa*Eriko ShimizuKazushi KimuraHitoshi EmiKosuke Nozaki
- Exhalation Valve Leakage Measured by a Negative Pressure Fit Test Method and Its Effect on the Measurement of Human Subject Fit FactorsRiedar K. Oestenstad*Stephanie M. Lynch
Rusch III, O. W., Reponen, T., Ronk, C. J., & McKay, R. T. (2008). Evaluation of User’s Ability to Seal Respirator Cartridge Inlet Openings of Different Sizes and Shapes. Journal of the International Society for Respiratory Protection, 25(3–4), 97–106. https://doi.org/10.66828/001c.167203